NACE CIP Level 1 & 2 Sample Quizes With 100% Correct Questions And Answers

NACE CIP Level 1 & 2 Sample Quizes With 100%
Correct Questions And Answers

All of the following are generally included within inspection reports EXCEPT - cost
information
When applying coatings, instruction regarding appropriate types of Personal
Protection Equipment (PPE) will always be found within the - material safety data
sheet (MSDS) or safety data sheet (SDS)
Material inventory report should contain all of the following EXCEPT - overall cost of
materials
According to the NACE attestation, it's OK to accept a gift from a contractor as long
as the gift is below the value identified in your company policy. - false
If the relative humidity is too high, solvent entrapment within the coating film may
occur. - true
The dew point is the - temperature at which moisture condenses on a surface.
While oxidation occurs at the anode, reduction occurs at the cathode - true
The coatings inspector must calibrate the magnetic surface thermometer at the job
site. - False
If solvent is trapped in a coating film it may - cause problems with the curing of the
film.
Electronic Surface Contact Thermometers - do not require stabilization prior to use
MOST coatings in the industrial and marine field are inorganic coatings? - False
The predominant pigment in sacrificial coating is - zinc
The vehicle of a coating consists of - solvent, binder, and liquid additivess
All of the following dissolve within the coating EXCEPT - pigments
Which coating type slows the penetration of oxygen, water, and soluble salts to form
electrolyte at the coating/metal surface? - barrier coatings
Mud cracking of an inorganic zinc-rich (IOZ) primer can be caused by - applying the
coating too thick
All corrosion of iron at normal ambient conditions is - an electrochemical process
Based on the galvanic series presented in the NACE CIP Level 1 Manual, which three
can be used effectively as galvanic anodes for carbon steel? - Zinc, aluminum,
magnesium
A decrease in temperature will generally cause the corrosion rate to - decrease
The electrolyte is the solution that carries (conducts) - the anion, and the cations
General corrosion is described as - uniform loss of thickness over the exposed
surface
A corrosion inhibitor is a substance that, when added to an environment - decreases
the rate of corrosion
The four elements of a corrosion cell are anode, the cathode, the electrode, and the
metallic pathway - False
A proper coating specification should contain information regarding - surface
preparation standards, safety, locations to be coated
The anode is the - part of the metal that corrodes
All of the following are commonly used as primers for steel structures EXCEPT - vinyl
esters
Convertible coatings cure by - a variety of polymerization mechanisms
Water-borne emulsions (latex) cure by a process known as - coalescence.
Alkyd coatings when applied to a highly alkaline surface will fail prematurely due to -
saponification
Prior to a project start, the inspector should do ALL of the following EXCEPT - direct
the application team during the mixing of the coating
Steel surface temperature reading should be taken - at the actual work locations
The requirements of a coating project should be defined by the - coatings
specification
A pre-job conference is helpful for reviewing - safety procedures, cleaning
procedures, application procedures, contractor's schedule
The abrasive blast cleaning of steel is - defined in several different standards
Which statement is true for the surfaces cleaned to a SSPC SP-11? - a power tool
standard for cleaning to bare metal with a minimum of 1 mil/25micron.
The NACE modified definition of a coatings specification is a formal document that
tells the contractor (applicator) what to do, where to do it, and how to do it. - false
The NACE No.2/SSPC SP-10 is a surface preparation standard for - near white blast
cleaning